Safety Check - Clarion SR5000 Installation Manual

4. Press and release the override switch within 5 seconds. The LED will flash in
groups indicating the last two zones that triggered the unit. The LED will flash
for one minute or until the ignition is turned off.
NOTE: The Warning Zone triggers are not stored to memory and will not be reported.

Safety Check

Before vehicle reassembly, the remote system must be checked to ensure safe and trouble-free
operation. The following test procedure must be used to verify proper installation and operation of
the system. The installation must be completed before testing, including connection to the brake
switch and hood switch.
1. Test the BRAKE shutdown circuit: With the vehicle in Park (P), activate the remote start system.
Once the engine is running, press the brake pedal. The engine should shut down immediately.
If the engine continues to run, check the brake circuit connection.
2. Test the HOOD PIN shutdown circuit: With the vehicle in Park (P), open the hood. Activate
the remote start system. The vehicle should not start. If the starter engages, check your hood pin
and connections.
Note: If programmed for Diesel Mode, the system will turn on the ignition, but the starter should
not engage with the hood open.
3. Test the NEUTRAL SAFETY shutdown circuit:
IMPORTANT! Make sure there is adequate clearance to the front and rear of the
vehicle before attempting this test.
a. Make sure the hood is closed and no other shutdown circuits are active.
b. Set the emergency brake.
c. Turn the ignition key to the run position but do not start the engine.
d. Put the vehicle in Drive (D).
e. Put your foot over the brake pedal but do not press down on it. Be ready to step on the brake
to shutdown the remote start system.
f. Activate the remote start system.
If the starter engages, immediately step on the brake to shut down the system. If it does
engage, recheck the neutral safety input connection. The vehicle may use a mechanical
38