Led, 2-Pin White Plug; Override Switch, 2-Pin Blue Plug - Clarion SR5000 Installation Manual

Door Lock Harness (H4),
Wire Connection Guide
___
Green
H4/A
___
Empty
H4/B
___
Blue
H4/C
IMPORTANT! The door lock outputs are low current and should not be attached
directly to any high current device; they are only to be used to activate relays
Peripheral Plug-In Harness

LED, 2-Pin WHITE Plug

The LED operates at (+) 2 volt DC and plugs into the two-pin WHITE port. Make sure the LED
wires are not shorted to ground as the LED will be damaged. Multiple LED's can be used, but they
must be wired in series. The LED fits into a 9/32-inch mounting hole. Be sure to check for clearance
prior to drilling the mounting hole.

Override Switch, 2-Pin BLUE Plug

The override switch should be accessible from the driver's seat. It plugs into the BLUE port on the
side of the unit. Since the system features valet by using the remote, the switch can be well hidden.
Consider how the button will be used before choosing a mounting location. Check for rear clearance
before drilling a 9/32-inch hole and mounting the button.The GRAY wire in the two-pin plug may
(-) Lock, (+) Unlock Output
(-) Unlock, (+) Lock Output
19