Installation; Installing Software And Documentation - GRASS VALLEY NV9640 User Manual

Table of Contents

Installation

Follow these steps to install a NV9640 control panel:

1 Mount, and secure, the panel in the rack.

The NV9640 is designed to mount in a 19" rack. Rack-mounting is not a requirement.

Place the panel in position in your rack. Attach the panel to the rack frame, using screws

appropriate for your rack. The panel's mounting slots are spaced 3.00" (76.2 mm) vertically

and allow approximately 1/8" (3 mm) of movement horizontally.

2 We assume that you have an Ethernet switch connected to the "Panel and Router Network"

port of your system controller. Connect an Ethernet cable from that switch to the RJ-45 port

at the rear of the NV9640.

3 Connect one or both power supplies. First connect the 4-pin connector to PS1 or PS2 on the

rear of the router. The connectors are keyed and snap into place. There is only one way they

fit. Do not force them. Then connect the power supply to AC power.

n.c.

A second power connection is for redundancy only (protection against failure) and is not a

requirement for operation.

Refer to

Power Cord Retention

4 Connect tally (GPIO) input devices and output devices at the DB25 GPI connector.

You can use the optional WC0053 breakout cable to make these connections.

See Chapter 6, GPIO, on page 75 for detail regarding the tally interface.

This document is available through the Grass Valley web site.

You must use NV9000-SE Utilities to configure the NV9640 control panel. Contact Grass Valley if

you need to obtain the latest version of this NV9000 configuration software.

You may use the Panel IP Configuration Utility if you want to your NV9640 to have a static IP

address or to use DHCP. The panel, as it comes from the factory, defaults to DHCP.

12 VDC

GND

Receptacle

Plug

Power Specifications

on page 81 for details on the PS0001 power supply. See also

on page 88.

n.c.

Table of Contents