Table of Contents
Advertisement
Default Name
System Name
Set
Multidest
(Selectable in
Device Limit
multiples of 8)
Checkbox Options
The checkbox options section is at the bottom of the panel options section:
A check in the box enables the option. Clearing the checkbox disables the option.
By default, all the check box options are clear except 'Src/Dst Immediate Take' . That particular
option is enabled by default.
The 'Clear Configuration' button removes all configuration data from the panel. The panel then
has a blank configuration. If you click this button by mistake, you can regain the previously
saved configuration by clicking the 'Revert to Saved' button.
The following items are the checkbox options:
•
User-Programmable ID.
Allows the Panel ID to be changed locally at the control panel (in menu mode).
•
Save Preset Default.
Makes 'Save Preset' mode active when the panel reverts to its default state (after a Default
State button is pressed, or when the panel is restarted).
A 'Save Preset' button is needed only when you want the operator to be able to view or
change the mode.
A list of "name sets" appears in the drop-down menu. The name
sets can be defined under the System Management pane of
NV9000-SE Utilities. Choose 'System Name' in this list if you do not
want, or do not care about, device name aliases. Do not choose
'System Name' if you are configuring any 'Name Set Toggle' but-
tons.
The number of multi-destination entries you are defining. (Strictly
speaking, this is not a limit, but a count.) The default, and lowest
value, is 8. The maximum is 512. (If you have more entries than
devices, you can leave some MD destinations unassigned.)
(If the configuration has 8 MD destinations, MD scrolling is dis-
abled.)
NV9640
User's Guide
21
Advertisement
Table of Contents
