Chapter 3 - Setup; Installation; Checking System Status - GRASS VALLEY OCP 400 User Manual

Chapter 3
Setup

3.1 Installation

1. Connect a power supply unit to the power input connector of the OCP 400.
2. Connect the Ethernet cable from the camera control (C2IP) network to the Ethernet
connector of the OCP 400.
☞ ☞
Note Note
It is recommended to use Grass Valley's LDK 5903 power supply unit with the OCP 400.

3.2 Checking system status

To check that XCU/Base Station and camera are connected correctly go to the Diag menu in
the setup menu.
– Push the SETUP button to open the menu.
Menu
Setup
– Push the SELECTION button to choose the Diagnostics menu. The diagnostics menu
OCP 400 Operational Control Panel User's Guide (v12.0)
Selections Function
DIAG Go to the Diagnostics menu
OCP Go to the OCP setup menu
BS Go to the XCU/Base Station
setup menu
CAM Go to the Camera setup menu
appears. Push NEXT and PREV to navigate through the different pages.

Chapter 3 - Setup

Level Possible values
S
S
S
S
19