Table of Contents
Advertisement
Operation
Operating Concepts
Quick Source
A quick source button selects a source and performs an immediate take.
Quick source and source buttons are similar, except that the quick source performs a take. Be
aware of which buttons are quick sources so you do not perform an accidental take.
Normally, the button text is the source's mnemonic, but the configurer can assign any text to the
button.
Salvo
This button executes a system salvo. A salvo is a pre-defined sequence of NV9000 commands.
The button text is the salvo name. When you press the salvo button, the panel temporarily
enters "salvo" mode and presents a message similar to this one on the display:
Salvo
Salvo
Execute
Execute
SD_Setup
SD_Setup
Press
Press
Take
Take
To confirm that you want to execute the salvo, press a 'Take' button. (You might have to navigate
to a 'Take' button.) When you press the take button, the salvo begins executing immediately.
Salvos are typically short in duration.
If you want to cancel the salvo before it executes, press the salvo button again.
System salvos are defined in NV9000-SE Utilities. You can review the defined salvos in NV9000-
SE Utilities or communicate with the panel's configurer regarding the function of any salvos in
your panel configuration.
Save Preset
This button is a toggle: it enables or disables "save preset" mode. When this function is enabled
(and the button is high tally), whatever is on preset is retained on preset after a take. When the
function is disabled (its button is low tally), whatever is on preset is discarded after a take.
The default button text is "Save Preset" but the button can have any legend.
Selection Buttons
Selection buttons correspond to the 8 lines of the alphanumeric display. A selection button
selects or deselects what appears on a line of the display. In X-Y mode, the display shows levels
and selection buttons select or deselect levels. In MD mode, the display shows MD destinations
and the selection buttons select or deselect MD destinations. A selection button is high-tally
when its associated level or MD device is selected and low-tally otherwise.
We assume here that if a button page in your panel has any selection buttons, it has exactly 8
selection buttons. Fewer than 8 result in problems; those in excess of 8 would be superfluous.
62
Preset
Status
Level/Dest
SD_Setup
SD_Setup
Salvo Name
Advertisement
Table of Contents
