Cisco ASR1002 Installation Manual page 45

Overview and installation
Hide thumbs Also See for ASR1002:
Table of Contents

Advertisement

Chapter 8
Cisco ASR 1002 Router Overview and Installation
One RJ-45 to RJ-45 crossover cable
One RJ-45 to DB-9 (female) adapter
A crossover cable reverses pin connections from one end to the other. In other words, it connects pin 1
(at one end) to pin 8 (at the other end), pin 2 to pin 7, pin 3 to pin 6, and so on. You can identify a
crossover cable by comparing the two modular ends of the cable. Hold the cable ends in your hand,
side-by-side, with the tabs at the back. Ensure that the wire connected to the outside (left) pin of the left
plug (pin 1) is the same color as the wire connected to the outside (right) pin of the right plug (pin 8).
Use the following procedure to connect a video terminal to the console port on a route processor.
Each Cisco ASR 1000 Series Route Processor 1 must have a console port connection (typically to a
Note
terminal server) if you are running a redundant configuration in the chassis.
Connect one end of the RJ-45 cables to the serial RJ-45 port (CON) on the Cisco embedded
Step 1
ASR1000-RP1 (see
Figure 8-36
1
CON port connection
Run the cable up and through the cable-management bracket and connect the other end of the RJ-45
Step 2
cable to the RJ-45 adapter (see
Connect the adapter to your video terminal to complete the cable connection.
Step 3
Power on your video terminal.
Step 4
Configure your video terminal to match the following default console port settings:
Step 5
9600 baud
8 data bits
No parity generation or checking
1 stop bit
No flow control
Step 6
Go to the
OL-13208-09
Figure
8-36).
Cisco ASR 1002 Router Console Port Connection on Cisco Embedded ASR1000-RP1
Figure
"Connecting Cables" section on page 8-46
Cisco ASR 1000 Series Aggregation Services Routers Hardware Installation Guide
Connecting a Terminal to the Cisco ASR1000-RP1 Console Port
MT S
CA RR IER
BO OT
QE 3
QE 2
QE 1
QE 0
ST AT
A S R 10 02
m in
st at
m aj
pw r
cr it
2
AUX port connection
8-36).
to continue the installation.
1
2
PW R STA
T
CO N
AU X
MG MT
LIN K
3-P OS
SPA -4X OC
8-45

Advertisement

Table of Contents
loading

Table of Contents