Cisco ASR1002 Installation Manual page 18

Attaching the Chassis Rack-Mount Brackets
Chassis Front Rack-Mount Brackets
Determine where in the rack you want the chassis to be mounted. If you are mounting more than one
chassis in the rack, then start from the bottom up or the center of the rack.
attached to the chassis. Depending on the bracket holes you use, the chassis may protrude in the rack.
To install the front rack-mount brackets on the Cisco ASR 1002 Router, perform the following steps:
Locate the threaded holes on the side of the chassis. Make certain that you hold the front rack-mount
Step 1
bracket with the ear and holes facing outward and towards the front of the chassis.
Figure 8-12
Figure 8-12
1
2
Position the front rack-mount bracket top hole with the chassis first top hole behind the side vent holes.
Step 2
Insert and tighten the black screws on one side.
Step 3
Repeat Step 1 through Step 3 on the other side of the chassis. Use black screws to secure the rack-mount
Step 4
brackets to the chassis.
Install the chassis in a rack. To install the Cisco ASR 1002 Router in a rack, go to the
Step 5
Cisco ASR 1002 Router in a Rack" section on page
This completes the steps for attaching the front rack-mount brackets to the Cisco ASR 1002 Router.
Chassis Rear Rack-Mount Brackets
If you are rack-mounting the chassis using the rear rack-mount brackets, then this type of installation
provides for the chassis being recessed in the rack.
To install the rear rack-mount brackets on the Cisco ASR 1002 Router, perform the following steps:
Cisco ASR 1000 Series Aggregation Services Routers Hardware Installation Guide
8-18
shows where to attach the front rack-mount brackets to the Cisco ASR 1002 Router.
Attaching the Front Rack-Mount Brackets to the Cisco ASR 1002 Router
3
2
Front rack-mount bracket ear and holes
Front rack-mount bracket
Chapter 8
AUX
MGM T
LINK
MTS
CAR RIER
BOO T
QE3
QE2
QE1
QE0
STA T
AS R 10 02
min
sta t
ma j
pw r
3-PO S
SPA- 4XOC
crit
1
3 Front rack-mount bracket screws
8-19.
Cisco ASR 1002 Router Overview and Installation
Figure 8-12 shows the brackets
3-PO S
SPA- 4XOC
PWR STAT
CON
3-PO S
SPA- 4XOC
"Installing the
OL-13208-09