Installation Methods - Cisco ASR1002 Installation Manual

Installation Methods

Table 8-6
Output Voltage
Minimum
Nominal
Maximum
Output Current
Minimum
Maximum
Any combination of output voltage/currents cannot exceed total power rating of 470 Watts.
Note
+24 VDC Power Supply Important Notices
The following items list important notes regarding the +24 VDC power supply in the Cisco ASR 1002
Router:
•
Table 8-7
Output
12V
3.3V
•
•
Installation Methods
Cisco ASR 1002 Router is designed for standalone, two rail 19-inch rack-mount (front rail only), four
rail 19-inch rack-mount (front and rear rail).
Although rack-mounting is the preferred method of installation for the Cisco ASR 1002 Router, you can
mount the chassis on an equipment shelf or tabletop.
Note The Cisco ASR 1002 Router usually ships fully loaded. However, you can remove components from the
chassis to make the chassis lighter for your rack installation, such as the power supplies.
Cisco ASR 1000 Series Aggregation Services Routers Hardware Installation Guide
8-12
Cisco ASR 1002 Router +24 VDC Power System Output Voltage and Current
Output Voltage Alarm Threshold—The Output Voltage Alarm is declared when the output voltage
is below the low end of the minimum or above the high end of the maximum limits (as shown in
Table 8-7). When the output voltage is above the high end of the minimum or below the low end of
the maximum limits, then the Red state is not activated.
+24 VDC Output Voltage Alarm Threshold Ranges
Temperature—If a single fan fails, the power supply meets the functional requirements specified in
Table 24. Above 55°C with less than two fans, calculated MTBF does not apply; however all
component stress remains within the manufacturer's specified rating.
Thermal Shutdown—The +24 VDC power supply will shut down to protect its components due to
excessive internal temperature. The +24 VDC power supply then automatically restarts if the
internal temperature returns to a safe operating level.
Chapter 8
+12 VDC
11.80
12.00
12.20
2.0 A
39 A
Minimum
10.0-11.2V
2.6 – 3.0V
Cisco ASR 1002 Router Overview and Installation
+3.3 V
3.20
3.30
3.40
0.10 A
3.125 A
Maximum
12.8-13.8V
None
OL-13208-09