Attaching The Cable-Management Bracket - Cisco ASR1002 Installation Manual

Chapter 8 Cisco ASR 1002 Router Overview and Installation
Tighten all screws on each side to secure the chassis to the equipment rack (see
Step 5
Figure 8-15
1
2
Use a level to verify that the tops of the two brackets are level, or use a measuring tape to verify that both
Step 6
brackets are the same distance from the top of the rack rails.
This completes the procedure for installing the chassis in the rack. Proceed to the
Cable-Management Bracket" section on page 8-23

Attaching the Cable-Management Bracket

The cable-management brackets mount to each rack-mount bracket on the chassis to provide
cable-management to both sides of the chassis (parallel with card orientation). These brackets are screw
mounted to the rack-mount brackets to allow easy installation and removal of cables.
The cable-management brackets for the Cisco ASR 1002 Router contain one independent
cable-management "U" type features with four screws and provides cable dressing of each card module
slot.
OL-13208-09
Cisco ASR 1002 Router on a Four-Post Rack—Front and Rear Rack-Mounting
1
2
Rear rack equipment rail
Rear rack-mount bracket ear and holes
Cisco ASR 1000 Series Aggregation Services Routers Hardware Installation Guide
Attaching the Cable-Management Bracket
AS R 10 02
min
stat
maj
pwr
crit
3
4
3
Front rack-mount bracket ear and holes
4
Front rack equipment rail
to continue the installation.
Figure 8-15).
SPA-4 XOC3 -POS
-POS
SPA-4 XOC3
-POS
SPA-4 XOC3
"Attaching the
8-23