Cisco Asr 1002 Router Power Supplies; Management Ethernet Port Cable Connection - Cisco ASR1002 Installation Manual

Cisco ASR 1002 Router Power Supplies

Management Ethernet Port Cable Connection

To comply with Class A emissions requirements, a shielded Ethernet cable must be used for the
Caution
connection.
To use the Management Ethernet interface on the router, perform the following steps:
Step 1 Insert an Ethernet RJ-45 cable into the MGMT ETHERNET port (see
Figure 8-21
1 MGMT - management port and cable
Insert the other end of the RJ-45 cable to your management device or network.
Step 2
Cisco ASR 1002 Router Power Supplies
This section describes the Cisco ASR 1002 Router power supplies and how to connect them:
•
•
•
Read the safety warnings before you begin.
Warning The covers are an integral part of the safety design of the product. Do not operate the unit without the
covers installed. Statement 1077
When you install the unit, the ground connection must always be made first and disconnected last.
Warning
Statement 1046
Cisco ASR 1000 Series Aggregation Services Routers Hardware Installation Guide
8-30
Cisco ASR 1002 Router Embedded ASR1000-RP1 Management Port Connector
Connecting AC Input Power to Cisco ASR 1002 Router, page 8-31
Connecting –48 VDC Input Power to Cisco ASR 1002 Router, page 8-34
Connecting Cisco +24 VDC Power Supply, page 8-38
Chapter 8 Cisco ASR 1002 Router Overview and Installation
MT S
CA RR IER
BO OT
QE 3
QE 2
QE 1
QE 0
ST AT
A S R 10 02
m in
st at
m aj
pw r
cr it
Figure 8-21).
1
T
PW R STA
CO N
AU X
MG MT
LIN K
3-P OS
SPA -4X OC
OL-13208-09