Cisco ASR1002 Installation Manual page 34

Cisco ASR 1002 Router Power Supplies
Do not run the AC power cord through the power supply handles as shown in
Caution
Figure 8-25
Note
Plug the AC power supply cable into the AC power source.
Step 4
This completes the procedure for connecting an AC power supply in the Cisco ASR 1002 Router.
Connecting –48 VDC Input Power to Cisco ASR 1002 Router
The –48 VDC power supply input connector is a Euro-style terminal block. A means to provide strain
relief to the input wires is provided on the power supply. The connection order is negative (–), positive
(+), and GND; but this is the order from left to right that the terminals appear on the power supply, not
the order in which the leads should connected during installation. The order the leads should be attached
is GND, positive (+), and negative (-).
The recommended branch circuit breaker for the Cisco ASR 1002 Router –48 VDC power supply is 30
A. Use a AWG #10 wire gauge on the 30 A circuit.
Cisco ASR 1000 Series Aggregation Services Routers Hardware Installation Guide
8-34
Incorrect Cabling on Cisco ASR 1002 Router AC Power Supply
OU TPU T
Thi s uni t
one pow er
All con nec
to de- ene
Using a tie wrap for the AC power cable is optional and not necessary. However, if you do attach
the AC power cable to a power supply tab and then you remove the AC power cable for some
reason, check for any damage to the cable after you cut the tie wrap off. If the power cord is
damaged, replace it immediately.
Chapter 8
INP UT
FAN
FAI L
OK
OK
mig ht hav
e mo re tha
sup ply con n
nec tion .
tion s mu st
be rem ove
rgiz e the d
uni t.
Cisco ASR 1002 Router Overview and Installation
Figure 8-25.
OU TPU T
INP UT
FAN
FAI L
OK
OK
Thi s uni t
mig ht hav
one pow er e mo re tha
n
sup ply con
All con nec nec tion .
tion s mu st
to de- ene be rem ove
rgiz e the d
uni t.
OL-13208-09