Cisco ASR1002 Installation Manual page 26

Attaching a Chassis Ground Connection
Figure 8-17
Figure 8-17
1 F0 with ASR1000-ESP5 or ESP10.
2 R0 slot with embedded ASR1000-RP1 and
embedded ASR1000-SIP10.
To attach the grounding lug to the chassis ground connector on your chassis, follow these steps:
Step 1 Use the wire stripper to strip one end of the AWG #6 wire approximately 0.75 inches (19.05 mm).
Insert the AWG #6 wire into the wire receptacle on the grounding lug. Use the manufacturers's
Step 2
recommended crimping tool to carefully crimp the wire receptacle around the wire; this step is required
to ensure a proper mechanical connection.
Cisco ASR 1000 Series Aggregation Services Routers Hardware Installation Guide
8-26
shows the location of the dual ground lug on the side of the of Cisco ASR 1002 Router.
Cisco ASR 1002 Router Chassis Ground Lug Location and Side Panel Door
4
3
Chapter 8 Cisco ASR 1002 Router Overview and Installation
PWR STAT
CON
AUX
MGMT
LINK
MTS
CARR IER
BOOT
QE3
QE2
QE1
QE0
STAT
AS R 100 2
min
stat
maj
pwr POS
SPA-4 XOC3-
crit
3 The eUSB panel door on the side of the Cisco
ASR 1002 Router must not be opened. If there
is a problem with eUSB flash card, the chassis
should be returned.
4 Cisco ASR 1002 Router ground stud location.
1
2
POS
SPA-4 XOC3-
POS
SPA-4 XOC3-
OL-13208-09