Assembling the MultiPASS
Assemble the MultiPASS as follows:
n
To see how the MultiPASS will look fully assembled, 1 Main Components of the
MultiPASS , p. 2-9.
1
Hold the document
support so that it
curves toward the
back of the unit and
fit the tabs of the
support into the
slots above the ADF.
3
The MultiPASS comes
with the document
tray already attached.
However, if you
accidentally remove
the tray, attach it by
fitting the slots on the
tray into the tabs on
the unit.
Chapter 2
2
Slide the output tray
into the rail on the
bottom of the unit.
Setting Up
2-5