Setting And Reading A Program Memory Address And Monitoring I/O Bit Status; Entering Or Editing Programs - Omron SYSMAC CPM2B Operation Manual

Programming Console Operations
6-2-6 Setting and Reading a Program Memory Address and Monitoring
I/O Bit Status
1, 2, 3...

6-2-7 Entering or Editing Programs

88
6. Press the WRITE Key to assign the displayed instruction to the function
code.
WRITE
This operation is used to display the specified program memory address and is
possible in any mode. In the RUN or MONITOR mode, the I/O bit status of bits in
the program will be displayed.
RUN
OK OK
When inputting a program for the first time, it is generally written to Program
Memory starting from address 000. Because this address appears when the
display is cleared, it is not necessary to specify it.
When inputting a program starting from other than 000 or to read or modify a
program that already exists in memory, the desired address must be desig-
nated.
1. Press the CLR Key to bring up the initial display.
2. Input the desired address. It is not necessary to input leading zeroes.
C A
2 0
3. Press the Down Arrow Key.
Pressing the MONTR Key will change to the I/O monitor display. Bits can be
force-set or force-reset from the I/O monitor display. Press the CLR Key to
return to I/O bit status monitoring of the initial address.
Note The ON/OFF status of any displayed bit will be shown if the PC is in
RUN or MONITOR mode.
4. Press the Up and Down Arrow Keys to scroll through the program.
This operation is used enter or edit programs. It is possible in PROGRAM mode
only.
RUN
No No
The same procedure is used to either input a program for the first time or to
change a program that already exists. In either case, the current contents of
Program Memory is overwritten.
INST TBL
FUN018:HEX
MONITOR PROGRAM
OK
00200
A
0
00200READ
↓
LD
00201READ
↓
AND
00200READ
↑
LD
MONITOR PROGRAM
OK
Section 6-2
READ
OFF
00000
In the RUN or MONITOR
mode, ON/OFF status of
the bit will be displayed.
ON
00001
OFF
00000