One-To-N Computer Connections - Omron SYSMAC CPM2B Operation Manual

System Configurations
1-2-5 One-to-one Computer Connections
RS-232C Port Connection
IBM PC/AT or Connecting Cable
compatible computer
XW2Z-200S-V (2 m)
XW2Z-500S-V (5 m)
RS-232C port
(D-sub 9-pin)
Use one of the connecting cables shown in the following diagram to connect a
personal computer with Support Software to the CPM2B for a 1:1 Host Link com-
munications or no-protocol (serial) communications.
Peripheral Port Connection
CPM2B CPU Board
Note 1. The CQM1-CIF11 Connecting Cable cannot be used. (If one is connected,
the CPM2C will not recognize it; the PC will enter RUN mode at startup if
Communications Switch SW201 is ON and DM 6600 of the PC Setup is set
to its default setting so that the Programming Console's mode switch con-
trols the startup mode.)
2. Refer to Appendix A Standard Models for details on the Support Software
that can be used with the CPM2B.
IBM PC/AT or CQM1-CIF02
compatible computer (3.3 m)
Connecting Cable
CPM1-CIF01
XW2Z-200S-V (2 m)
RS-232C Adapter
XW2Z-500S-V (5 m)
Section 1-2
CS1W-CN114
(0.05 m)
Peripheral port
CPM2B CPU Board
9