Adjusting The Punch Hole Position - Canon SADDLE FINISHER K3 Service Manual

100/230V model (2-hole)
Direction
of feed
115V (3-hole)
Direction
of feed
F05-101-18
5) Press SW976 on the switch PCB.
• The machine will accept the new set-
ting.
6) Turn off the power.
7) Shift all bits of SW973 to OFF.
The setting may be
changed in the copier's ser-
vice mode:
Memo
SORTER>PNCH-HLE.
COPYRIGHT© 2001 CANON INC.
Shift of the hole
position by a press
on SW975
Shift of the hole
position by a press
on SW974
Shift of the hole
position by a press
on SW9775
Shift of the hole
position by a press
on SW974
2000 2000 2000 2000 CANON SADDLE FINISHER K3/K4 REV.0 MAR. 2001
CHAPTER 5 TROUBLESHOOTING
1.1.9 Adjusting the Punch Hole
Position (in direction of
horizontal registration)
1) Make a copy in punch mode, and check
the position of the punch holes.
100/230V Middle of paper
model
(2-hole)
Vertical displacement (in left/right direction in figure)
of the two hole in relation to the middle of paper is ±
1 mm.
115V Middle of paper
model
(3-hole)
Vertical displacement (in left/right direction) of the
middle hole in relation to the middle of paper is ± 1
mm.
F05-101-19
Regardless of the mode of
delivery (face up or face
down), make a check with
the top face of the sheet de-
livered in the tray as the top
face.
2) Set SW973 of the switch PCB as indi-
cated:
ON
1 2 3 4 5 6 7 8
F05-101-20
Direction
of feed
Direction of
feed
5-11