You can find out whether the
protrusion is matched against
the round hole (large) with ref-
Memo
erence to the small hole [3] on
the drive belt side.
1.3.6 Adjusting the Position of the
Sub Tray Solenoid (SL3; with
paper folding unit istalled)
1) Remove the tray B.
2) Disconnect the connector [1] of the sub
tray solenoid cable.
3) Check to make sure that the support
member [2] of the lever unit is not stick-
ing beyond the tray face [3]. If it is, ad-
just the height as follows:
COPYRIGHT© 2001 CANON INC.
2000 2000 2000 2000
CANON SADDLE FINISHER K3/K4 REV.0 MAR. 2001
CHAPTER 3 MECHANICAL SYSTEMS
F03-103-12
[1]
F03-103-13
[2]
F03-103-14
[3]
[3]
[3]
3-23