Jam Detection - Canon SADDLE FINISHER K3 Service Manual

CHAPTER 2 OPERATION OVERVIEW

14.7 Jam detection

Jam detection checks are carried out at intervals pre-programmed in the ROM of the fin-
isher controller PCB. A jam is detected in relation to the presence or absence of paper at a
specific sensor. When a jam is detected, the finisher controller PCB communicates the na-
ture of the jam to the copier in the form of a code. The code can be checked in the copier's
service mode, or by reference to LED101 on the finisher controller PCB.
2-168
COPYRIGHT© 2001 CANON INC.
PI64/65
S9
S9 : Inserter paper set sensor
PI62 : Inserter feed sensor 1
PI63 : Inserter feed sensor 2
PI61 : Inserter feed sensor 3
PI59 : Saddle inlet paper sensor
PI1 : Saddle paper sensor 1
PI64 : Inserter cover open sensor (front)
PI65 : Inserter cover open sensor (rear)
F02-1407-01
2000 2000 2000 2000 CANON SADDLE FINISHER K3/K4 REV.0 MAR. 2001
PI62
PI63
PI61
PI59
PI1