Table of Contents
Advertisement
P/N 0520677_W
INSTALLING BUMPERS
Offsetting the bumpers and top rails helps to
disguise the joint locations, giving the lineup a
smoother look.
Begin at the left end of the line-up. A starter
bumper is factory-installed with end kits. Insert
the internal joint trim, then add the full-length
bumper.
Align each bumper section with its retainer and
push into place, working from the end of the
lineup. Install full length bumpers and internal
joint trims offset across joints. Make sure
that no gaps exist between sections. Continue
installing bumpers the length of the line up.
Merchandiser
Joint
Internal Joint
Trims
HUSSMANN CORPORATION • BRIDGETON, MO 63044-2483 U.S.A.
Merchandiser
Joint
Full Length
Bumpers
Starter
Bumper
Do NOT install the last bumper sections at this
time. These sections will be installed in the last
step.
Once all except the last section of bumper have
been installed, refrigerate the case line-up for at
least six (6) hours. The last sections of bumper
should be kept inside a refrigerated case or
cooler during this time to allow the bumpers to
contract.
Before installing the last full-length section,
measure the remaining space. Use a miter box
and fine-tooth saw to cut last bumper to length.
Install the last section. Remove protective film
from bumpers once installation is complete.
Optional end bumpers are factory-installed.
Miter Box
Bumper
Bumper End
Caps can
be adjusted
horizontally to
eliminate gaps.
Freedom Line Reach-in
1-19
Advertisement
Table of Contents
