Installing Bumpers - Hussmann Insight Installation & Operation Manual

1-14

INSTALLING BUMPERS

1 . Bumpers are packed out with the case and
snap onto the bumper retainer . Gaskets are
factory installed in the bumper retainers to provide
support for the bumpers . Do not remove the
gaskets .
2 . Bumper joint inserts are provided with the
case to disguise joints for a lineup of cases .
3 . Start at the left end of the lineup . Install 3ft
starter bumper first . Refer to bumper side view
illustration to ensure the bumper is orientated
correctly . Place top of bumper over bumper
retainer, then snap bottom of bumper into place
at bottom of retainer . Position internal joint trim
between the starter bumper and full-length
bumper .
TOP
BOTTOM BOTTOM
Door Case All other Cases
Bumper
Bumper
Orientation
Orientation
Bumper Side View
P/N 3032067_E
Bumpers come in two styles —
Ellipse and Faceted.
TOP
Bumper
Installed
on Case
U.S. & Canada 1-800-922-1919 • Mexico 01-800-890-2900 • www.hussmann.com
4 . Continue installing bumper(s) until the
lineup is complete . The last piece of bumper
will need to be cut so that it is flush with the
right end cap . Use a fine tooth saw to cut the
bumper vertically at a 90° angle .
5 . Ensure joint trim is positioned behind
bumper at all joints to close any gaps in the
lineup . Remove protective film from bumper
once installation is complete .
Ellipse Bumper
End
END ASM
Assembly
3 FOOT
3-ft Starter
STARTER
Bumper
BUMPER
Joint Trim
JOINT TRIM
goes behind GOES BEHIND
THIS SEAM
this Seam
Faceted Bumper
2
2 9
Bumper BUMPER
SEAM
Seam
FULL
Full-Length
LENGTH
Bumper
BUMPER
STARTER &
Starter &
FULL LENGTH
Full-Length
BUMPER SEAM
MUST ATTACH
Bumper Seam
TO MULTI
must attach to
SUPPORT
Multi-support E W V I D E S I
: 1 . 6 E 1 A L S C
2
2 9