Table of Contents
Advertisement
o
6-6
ptIonal
Do NOT use Thread Sealer on Drain Fitting!
1. Tee is factory-installed. If adjustment is
necessary, tighten factory-installed tee no
more than ¼ turn. Do not overtighten
threads, or the drain fitting or tee may
become damaged.
2. Do NOT use thread sealer on ABS drain
fitting. If sealer is used the ABS drain fitting
may crack or leak! (If a tee needs to be
installed it should be hand tightened).
Do not overtighten threads.
3. Dry fit the supplied
water seal / trap to
ensure approximately
1
/
in. of clearance from
2
the bottom of the trap
to the floor as shown.
P/N 0520677_W
d
p
rIp
IpIng
1
/
Approx.
in. Clearance to Floor
2
Merchandiser
Bottom
Maintain Clearance
to Bottom of Case
Field-Installed
Water Seal
Floor
U.S. & Canada 1-800-922-1919 • Mexico 1-800-890-2900 • WWW.HUSSMANN.COM
(Drain Fitting)
Factory Installed (four turns)
Factory-Installed
Tee Fitting
NOTE: It may be necessary to rotate water
seal (trap) inside the tee a few degrees to ensure
clearance at two locations. There must be
clearance 1) between the bottom of the water
seal and the floor, and 2) between the top of
the water seal outlet and the bottom of the
merchandiser. Do not over-rotate or gravity
seal may be compromised. Always rotate trap
bottom toward merchandiser support rail.
Merchandiser
Waste
Outlet
Rotate Water Seal
towards back of
Merchandiser if required
/
-in.
1
2
Clearance to Floor
Front of
Advertisement
Table of Contents
