Table of Contents
Advertisement
I
1-2
nstallatIon
To prevent sweating on the exterior surfaces
of merchandisers, there must be
4
clearance of
inches
merchandisers and other fixtures or walls.
A 5.5 inch (140 mm) space is required between
facade top and the ceiling. A louvered Facade
Panel kit is available that will allow for a top
spacing minimum clearance of 4 inches (102 mm).
Product should always be maintained at
proper temperature. This means that from the
time the product is received, through storage,
preparation and display, the temperature of the
product must be controlled to maximize the life
of the product. Condensing units installed on
top of the merchandiser require air circulation
to operate properly. Blocking or restricting
air flow will adversely affect performance
and may damage the refrigeration system. If
the ceiling and/or walls are built up around
the merchandiser, allow for a sufficient gap
above or behind the merchandiser to provide
adequate air circulation. When merchandisers
are installed in a lineup, case must be taken
to ensure that warm condenser air is not
blown from one unit into the condenser of the
adjacent unit.
SHIPPING DAMAGE
All equipment should be thoroughly examined
for shipping damage before and during
unloading. This equipment has been carefully
inspected at our factory. Any claim for loss
or damage must be made to the carrier. The
carrier will provide any necessary inspection
reports and/or claim forms.
Apparent Loss Or Damage
If there is an obvious loss or damage, it must be
noted on the freight bill or express receipt and
signed by the carrier's agent; otherwise, carrier
may refuse claim. The carrier will supply
necessary forms.
P/N 0520677_W
a minimum
(102
) between the
mm
U.S. & Canada 1-800-922-1919 • Mexico 1-800-890-2900 • WWW.HUSSMANN.COM
Concealed Loss Or Damage
When loss or damage is not apparent until
after equipment is uncrated, a claim for
concealed damage is made. Upon discovering
damage, make request in writing to carrier
for inspection within 15 days and retain all
packing. The carrier will supply inspection
report and required claim forms.
EXTERIOR LOADING
Do NOT walk on top of merchandisers or
damage to the merchandisers and serious
personal injury could occur. T
noT sTrucTurally designed To supporT
excessive exTernal loading
weight of a person. Do not store items or
flammable materials on top of the case.
MERCHANDISERS SHIPPED WITH END
INSTALLED
If the case was shipped with the end installed,
two long bolts were used to hold the shipping
brace to the end. If the shipping bolts are
reinserted after removing the brace, they will
extend into the product area and may damage
the coil. T
,
herefore
These bolTs wiTh The shorTer bolTs
.
provided
Be careful not to damage the factory-installed
end while moving the merchandiser. Make
sure that tools are positioned past the end and
beneath the merchandiser's support bar.
SHIPPING BRACES
Move the merchandiser as close as possible
to its permanent location and then remove all
packaging. Check for damage before discarding
packaging. Remove all separately packed
accessories such as kits and shelves.
hey are
such as the
be sure To replace
Advertisement
Table of Contents
