Installing Bumpers - Hussmann microDS Insight ID6SU-W Installation & Operation Manual

1-28

INSTALLING BUMPERS

1. Bumpers are packed out with the case and
snap onto the bumper retainer. Gaskets are
factory installed in the bumper retainers to provide
support for the bumpers. Do not remove the
gaskets.
2. Bumper joint inserts are provided with the
case to disguise joints for a lineup of cases.
3. Start at the left end of the lineup. Install 3ft
starter bumper first. Refer to bumper side view
illustration to ensure the bumper is orientated
correctly. Place top of bumper over bumper
retainer, then snap bottom of bumper into place
at bottom of retainer. Position internal joint trim
between the starter bumper and full-length
bumper.
TOP
BOTTOM BOTTOM
Door Case
All other Cases
Bumper
Bumper
Orientation
Orientation
Bumper Side View
P/N 3074287_H
Bumpers come in two styles —
Ellipse and Faceted.
TOP
Bumper
Installed
on Case
U.S. & Canada 1-800-922-1919 • Mexico 01-800-890-2900 • www.hussmann.com
4. Continue installing bumper(s) until the
lineup is complete. The last piece of bumper
will need to be cut so that it is flush with the
right end cap. Use a fine tooth saw to cut the
bumper vertically at a 90° angle.
5. Ensure joint trim is positioned behind
bumper at all joints to close any gaps in the
lineup. Remove protective film from bumper
once installation is complete.
Ellipse Bumper
End
END ASM
Assembly
3 FOOT
3-ft Starter
STARTER
Bumper
BUMPER
Joint Trim
JOINT TRIM
goes behind GOES BEHIND
THIS SEAM
this Seam
Faceted Bumper
2
2 9
BUMPER
Bumper
SEAM
Seam
FULL
LENGTH
Full-Length
BUMPER
Bumper
Starter &
STARTER &
FULL LENGTH
Full-Length
BUMPER SEAM
Bumper Seam
MUST ATTACH
TO MULTI
must attach to
SUPPORT
Multi-support
E W V I D E S I
: 1 . 6 E 1 A L S C
2
2 9