Table of Contents
Advertisement
Table 11: Supported and unsupported email configurations lists the supported and unsupported email
configurations.
Table 11: Supported and unsupported email configurations
Type
By encryption:
No encryption
SSL/TLS
STARTTLS
By authentication:
SMTP servers which
support/require authentication
SMTP servers which do not
support authentication
To configure notifications:
1. On the Notifications page, select the Email check box, and then click Continue.
2. Enter values for SMTP server, Sender email, Protocol, SMTP port, Sender password, and
Confirm password.
3. In the Receiver email addresses, you can enter multiple email addresses separated by comma
(,).
4. Click Send test email to verify the email configuration. If you do not receive test email on the
configured email addresses, then check the email configuration.
5. Click Apply and Continue to open the Summary page.
10.6 | Verifying onboarding configuration
The Summary page displays all the onboarding configurations. You can verify the configurations and if
required, go back to a page to change the configurations. After verifying the configurations, the
system moves to the new IP address added during the configuration. You must use the new IP
address to access the system.
To verify the configurations:
•
Review the configurations, and then click Continue.
The Confirmation pop-up displays the new IP address of the system. You must use the new
IP address to access the system.
The installation of Lyve Rack system is now complete. To start using the system, refer the Lyve Rack
R1 User Guide.
Supported/Unsupported
Supported
Supported
Supported
Supported
Not supported
43
Lyve Rack R1 Installation Guide
Advertisement
Table of Contents
