Management Network - Seagate Lyve Rack R1 Installation Manual

7.2 | Management network

Management network can be configured using Static virtual IP addresses or DHCP-assigned IP
addresses.
Note
Lyve Rack R1 does not support mixed mode IP configuration, that is if you chose to
configure static virtual IP addresses for the management network you must
configure static virtual IP addresses for the public data as well. Configuring one
network using static virtual IP addresses and another as DHCP-assigned IP addresses
is not supported.
Refer to the Information sheet to know the MAC addresses.
Static virtual IP configuration:
User must be aware of IP addresses, subnet masks, and IP of the gateway.
DHCP configuration:
Configure DHCP server to assign the same (static) IP and hostname to each provided MAC addresses
instead of taking them from DHCP pool. These entries should be corresponding to:
a) Management network for the server - one IP address per server
b) BMC network for the server - one IP address per server
The total number of required IP addresses for management and BMC interfaces: four (4).
In addition to these the DHCP server should also be configured to provide optional info for:
• subnet mask
• name server
• domain name
• gateway
DNS server: Regardless of the IP configuration method, DNS server should have the mappings
for the above assigned hostnames and IP addresses - both A-record and reverse lookup record.
Lyve Rack R1 Installation Guide
31