Seagate Lyve Rack R1 Installation Manual page 45

csm-web (systemd:csm_web): Started srvnode-2
csm-agent (systemd:csm_agent): Started srvnode-2
uds (systemd:uds): Started srvnode-2
stonith-c1 (stonith:fence_ipmilan): Started srvnode-2
stonith-c2 (stonith:fence_ipmilan): Started srvnode-1
Daemon Status:
corosync: active/enabled
pacemaker: active/enabled
pcsd: active/enabled
[root@mfg-cortx-node1 boxing]#
6.
If there are any failures, identify the resource that is shown as a failure. Use the following
command to perform a cluster resource cleanup.
pcs resource cleanup <resource_name>
If above procedure does not work, then check all the Lyve Rack R1 cables are plugged in
properly and link/activity LEDs are ON. Check if there are any fault LEDs. If you cannot find
the fault contact Seagate support with a copy of the Information sheet to hand.
7.
A final Cluster verification step. Referring to the Lyve Rack R1 Information sheet, from the
Management Console laptop, open a command shell and ping the Cluster floating IP addresses
(Management VIP and Data VIP). These two addresses should now respond as the Cluster is
functional.
Lyve Rack R1 Installation Guide
40