Table of Contents
Advertisement
DAT Autoloader Installation Manual
Internal configuration switches
Two additional sets of dip switches are located inside the
autoloader drawer (see Figure 5). These are used to adjust
the 8-character LED display and other settings.
Figure 5. Location of internal dip switches
Bank of four dip switches
(below rubber plug)
To access these switches, you must use the following
procedure.
1. Power-on the drive.
2. Open the autoloader drawer by pressing the Open/Close
3. Power-off the drive.
4. Set the appropriate dip switches.
5. Power-on the drive.
6. Press the Open/Close button to close the drawer.
Bank of seven dip switches
(on top of drawer)
C a
s s e
t t e
D C
Note. To access the bank of seven dip switches on the
top of the drawer, the drive must be powered on and the
autoloader must be outside of a system enclosure.
button on the front bezel.
D r
i v e
O p
e n
/ C l
o s
e
W r
i t e
P r o
t e c
t
S t e
p
Note: Drawer must be open
to view switches
11
Advertisement
Table of Contents
