Table of Contents
Advertisement
22
Hawk 2LP Family Installation Guide, Rev. A
_ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _
Drive configuration
Each disc drive has one or more option select header connec-
tors on the back, side or front where jumper plugs are installed
to select the way that the drive is to be configured or to select
its ID on the I/O bus. See notes following Figure 3b.
Hawk 2LP family N/ND models (50 pin SCSI I/O)
On Model N/ND drives either J6 (on the front of the drive) or
J5 (on the side behind the DC Power connector) may be used
to set the drive ID. To avoid possible incorrect ID setting, do not
use both J5 and J6 for ID selection. The following figures show
where these headers are located on the different drives cov-
ered by this manual. See notes following Figures 3a and 3b
where explanations are given about the purpose of each
jumper and specify the standard factory (called "default")
settings of these jumpers (i.e., settings used for most common
single drive application). Changes to these settings should be
made only if it is known that the system requires a different
configuration.
Advertisement
Table of Contents
