Table of Contents
Advertisement
1.
Using Cat5/6 cable, connect laptop to the CORTX Manager configuration Port on the Server A.
Refer to the Figure 14 or Figure 15 for the port location.
2.
On the Management Console Laptop, connect to server A using the SSH command and IP
address 10.100.100.100. Use the single-use password for the user cortxub from the Lyve
Rack R1 Information sheet. The user credentials work only on Server A.
ssh cortxub@10.100.100.100
3.
Run the cluster initialization script. The cluster initialization script creates the cluster and
initializes the cluster by assigning IP addresses to it. Run the following command on server A.
You must wait for few minutes for the script to complete.
sudo sh/opt/seagate/cortx/provisioner/cli/factory_ops/unboxing/init -M
<MANAGEMENT_VIP> -C <DATA_VIP>
4.
During the execution of the script you will be prompted to provide the following information:
•
Type of IP address configuration (static or DHCP)
•
IP addresses, subnet masks, and gateway information of each server (only for static
virtual IP configuration)
•
Fully qualified domain names of each server.
Important
Refer to the Appendix to see an execution sequence example of the unboxing script.
5.
The clusters are created after the process is complete. Run the following command to validate
if the cluster is functional:
sudo pcs status
The command must display all the cluster resources' status as started. The status must not
display failure.
Example exert
...
s3server-c2-7 (systemd:s3server@0x7200000000000001:0x7d): Started srvnode-2
s3server-c2-8 (systemd:s3server@0x7200000000000001:0x80): Started srvnode-2
s3server-c2-9 (systemd:s3server@0x7200000000000001:0x83): Started srvnode-2
s3server-c2-10 (systemd:s3server@0x7200000000000001:0x86): Started srvnode-2
s3server-c2-11 (systemd:s3server@0x7200000000000001:0x89): Started srvnode-2
mero-free-space-mon (systemd:mero-free-space-monitor): Started srvnode-1
Master/Slave Set: sspl-master [sspl]
Masters: [ srvnode-2 ]
Slaves: [ srvnode-1 ]
Resource Group: csm-kibana
kibana-vip (ocf::heartbeat:IPaddr2): Started srvnode-2
kibana (systemd:kibana): Started srvnode-2
Lyve Rack R1 Installation Guide
39
Advertisement
Table of Contents
