Table of Contents
Advertisement
•
The plug on the power supply cord is used as the main disconnect device. Ensure that the
socket outlets are located near the equipment and are easily accessible.
•
When powered by multiple AC sources, disconnect all power supplies for complete isolation.
•
In order to comply with applicable safety, emission, and thermal requirements no covers
should be removed, and rear panel must be populated with plug-in modules.
•
The power connection should always be disconnected prior to insertion or removal of a PSU
from the enclosure.
•
Do not attempt to disassemble the rear sub-chassis from the enclosure.
•
Provide a suitable power source with electrical overload protection to meet the requirements
laid down in the technical specification.
•
If any component of the product fails, consult Seagate support.
•
For North American use, each branch circuit must be rated for 20A.
•
The equipment is suitable for connection to an IT power system (Norway), when mounted in a
Restricted Access Location where equipotential bonding has been applied by a service person.
Important
The optional RJ45 socket on the controller module is for Ethernet connection only
and must not be connected to a telecommunications network.
Caution
•
Operating temperatures inside the enclosure drawers can reach up to 60°C. Be careful
while opening drawers and removing drive carriers.
•
Double pole/neutral fusing in PSUs.
•
Risk of explosion if the battery within the controller is replaced with an incorrect
type. Dispose used batteries according to the instructions. There are no user
serviceable parts within the controller.
•
Due to product acoustics ear protection must be worn during prolonged exposure to
the product in operation.
•
To prevent over-turning, drawer interlocks stop users from opening both drawers at
the same time. Do not attempt to force open a drawer when the other drawer is
already open.
Lyve Rack R1 Installation Guide
8
Advertisement
Table of Contents
