Infocenter Display - Toro Greensmaster e1021 Service Manual

InfoCenter Display

Electrical System: Electrical System Operation
g338445
1. Handle
The InfoCenter display used on your Greensmaster e1021/e1026 is a LCD
device that is located on the handle console
information to the operator during the operation of the machine, provides
electrical system diagnostic assistance for the technicians, and allows inputs
for the adjustable machine settings.
Power for the InfoCenter is available when energized by the TEC (the key
switch is in the START or RUN position). A CAN-bus system involving the
TEC, electric motor controller, and lithium-ion battery pack provides necessary
machine communication for the InfoCenter operation.
Note: Icons that are used on the InfoCenter display are identified in the Traction
Unit Operator's Manual.
Note: If the InfoCenter display is replaced for any reason, the machine software
must be updated; contact an Authorized Toro Distributor for assistance.
Figure 34
2. InfoCenter display
(Figure
Page 5–10
34). The InfoCenter provides
Greensmaster ® e1021/e1026
20246SL Rev A