Toro Greensmaster e1021 Service Manual page 184

Installing the Reel Assembly (continued)
DPA Cutting Units: Service and Repairs
To avoid grinding the reel, do not contact the cutting edge of
any blade with the pry bar as this may damage the cutting edge
and/or cause a high blade.
B. Move the pry bar against the weld side of the reel support plate closest
to the bearing lock screw.
The reel drive shaft on the left end of the cutting reel has left hand
threads. The bearing lock screw on the right end of the cutting
reel has right- hand threads.
C. Rest the handle of the pry bar against the front roller and tighten the
bearing lock screw from 123 to 149 N·m (90 to 110 ft-lb).
Do not use 1/2" extension on end of reel drive shaft when
loosening or tightening drive shaft. The 1/2" hex is intended for
back lapping only.
D. Position the pry bar in the same manner on the opposite end of the reel
and use the appropriate wrench or socket on the 1" hex portion of the
shaft to tighten the reel drive shaft from 123 to 149 N·m (90 to 110 ft-lb).
7. Secure the grass shield assembly (18) to the RH and LH side plates (4 and
10) with the 2 washers (15) and 2 bolts (16).
8. If the reel nuts were loosened during cutting reel service, put a block of wood
between the cutting reel blades to prevent the reel from rotating and tighten
the reel nuts from 123 to 149 N∙m (90 to 110 ft-lb).
9. Install the reel drive assembly; refer to
(page 4–10). Grease the splines with high temp Mobil XHP−222 grease
or equivalent.
10. Install the bedbar assembly; refer to
11. Install the front roller; refer to
12. Install the cutting unit assembly to the frame assembly; refer to
Cutting Unit Assembly (page
13. If the cutting unit is equipped with an optional groomer, install the components
for those options. Refer to
for universal groomer, and
information.
IMPORTANT
IMPORTANT
IMPORTANT
Installing the Reel Drive Assembly
Installing the Bedbar (page
Installing the Front Roller (page
7–16).
Removing the Gear Box Assembly (page 8–4)
Universal Groomer (page 2–4)
Page 7–22
7–8).
7–27).
Installing the
for additional
Greensmaster ® e1021/e1026
20246SL Rev A