Bedknife Screw Tool (continued)
K-Line Part No. TOR510880A
This screwdriver-type bit is made to fit Toro bedknife
attaching screws. Use this bit with a torque wrench to secure
the bedknife to the bedbar.
IMPORTANT
Important: To prevent damage to the
bedbar, DO NOT use an air or manual
impact wrench with this tool.
Diameter/Circumference Measuring Tape
K Line Part No. TOR6023
Spring steel measuring tape for accurately measuring the
circumference and outside diameter of cutting reel and
other spherical components. Tape calibration is in fixed inch
readings (no adjustments).
Roller Rebuilding Tools
The following combination of washers and spacers can be
used to install bearings and seals into the front and rear rollers
(2 each required).
Bearing installation washer: 107-8133 (black)
Seal installation spacer: 107-3505
Seal installation washer: 104-6126 (yellow)
K-Line Part No. TOR4105
As an alternative to using the washers and spacer listed
above, this special tool set can be used to install bearings and
seals into the front and rear rollers.
Specifications and Maintenance: Special Tools
Page 2–16
Greensmaster
®
e1021/e1026
20246SL Rev A