Toro Greensmaster e1021 Service Manual page 175

Installing the Bedknife (continued)
Grinding the Bedknife
Greensmaster ® e1021/e1026
20246SL Rev A
Do not use an impact wrench to tighten screws into the bedbar.
3. Use new screws to secure bedknife to bedbar. Apply anti-seize lubricant to
the threads of new screws. Do not apply anti-seize lubricant to the taper
of the screw heads.
4. Install all screws but do not tighten.
5. Using a torque wrench and bedknife screw tool, tighten the 2 outer screws to
1 N·m (10 in-lb).
6. Working from the center of the bedknife toward each end, tighten screws
from 23 to 28 N·m (200 to 250 in-lb).
7. After installing the bedknife to bedbar, grind the bedknife.
Bedknife Grinding Specifications
Standard Bedknife Relief Angle
Fairway Bedknife Relief Angle
Extended Bedknife Relief Angle
Front Angle Range
g207289
1. Top angle
2. Top surface
3. Remove burr
Since there can be variations in the mounting surface of the bedbar, it is
necessary to grind the bedknife after installing it to the bedbar. Follow
the bedknife grinding specifications provided; refer to
Specifications (page 7–13). Grind only enough so the top surface of the bedknife
is true; refer to Figure
IMPORTANT
Figure 102
4. Front surface
5. Front angle
102.
Page 7–13
3° minimum
3° minimum
7° minimum
13° to 17°
Bedknife Grinding
DPA Cutting Units: Service and Repairs