Toro Greensmaster e1021 Service Manual page 170

Installing the Bedbar
DPA Cutting Units: Service and Repairs
g226763
1. Side plate
2. Rubber bushing
3. Nylon bushing
4. Plastic washer (2 each)
1. If rubber bushing (item 4 in
apply grease to outside surface of new bushing and install into side plate
(1). The bushing (4) should be installed flush with the inside surface of the
side plate; refer to
2. If removed, install the nylon bushings (5) with flange facing outward.
3. Apply anti-seize lubricant to the threads and shank of each bedbar bolt (8);
refer to Figure 98.
Contact with the reel, bedknife or other cutting unit parts can result
in personal injury. Use heavy gloves when handling the bedbar.
Note: If a new bedknife is attached to the bedbar, there may be interference
between the bedknife and the reel when installing the bedbar. Turn the
bedbar adjusting screws counterclockwise to increase bedknife clearance
if necessary.
4. Position the bedbar assembly (16) into the cutting unit. Make sure that the
top of each bedbar arm is between the washer (17) and adjuster screw
flange (12).
When installing the washers, make sure that the plastic washers (6
and 15) are positioned against the side plate.
5. Position one plastic washer (6 and 15) between the bedbar (16) and each
side plate (1).
6. Slide a metal washer (7) onto the bedbar bolt (8).
Figure 98
5. Metal washer
6. Bedbar
7. Bedbar pivot bolt
8. Lock nut
Figure 98) was removed from either side plate,
Figure 98.
CAUTION
IMPORTANT
Page 7–8 Greensmaster ® e1021/e1026
20246SL Rev A