Toro Greensmaster e1021 Service Manual page 55

Disassembling the Reel Drive Assembly (continued)
Assembling the Reel Drive Assembly
Greensmaster ® e1021/e1026
20246SL Rev A
9. Remove the retaining ring (6) from the reel drive housing (22).
10. Slide the reel shaft-driven from the bearings.
11. Use a press to remove the 2 ball bearings (5) and reel shaft-driven (1) from
the reel drive housing (22). Discard the ball bearings after removal.
12. If necessary, remove the pivot sleeve (3) from the reel drive housing (22).
Remove and discard the O-ring from the pilot sleeve.
13. Remove the nut (9), reel pulley (15), hipro key (20) and spacer (7) from the
reel shaft-driver (21).
14. Remove the retaining ring (17) from the reel drive housing (22).
15. Slide the reel shaft-driver from the bearings.
16. Use a press to remove the 2 ball bearings (18), bearing shield (19) and reel
shaft-driver (21) from the reel drive housing (22). Discard the ball bearings
after removal.
17. Remove and discard the O-ring (23) from the bolt (24). If necessary, remove
the bolt (24) from the reel drive housing (22).
1. If removed install the bolt (24) into the reel drive housing (22) and new O-ring
(23) onto the bolt (24).
2. Use a press to install the 2 ball bearings (18) into the reel drive housing (22)
and make sure that the reel shaft-driver pushes on bearing outer raceway.
3. Slide the bearing shield (19) onto the reel shaft-driver.
4. Install the reel shaft-driver (21) into the reel drive housing (22).
5. Install the retaining ring (17) to the reel drive housing (22).
6. Slide the spacer (7) onto the reel shaft-driver (21).
7. Install hipro key (20) to then reel shaft-driver (21). Apply anti-seize lubricant
at the top of the key.
8. Install the reel pulley (15) onto the reel shaft-driver (21). Secure the reel
pulley (15) with the lock nut (9).
9. Torque tighten the lock nut to 36.6 to 44.7 N∙m (27 to 33 ft-lb).
10. If removed, install the O-ring (2) onto the pivot sleeve (3). Slide the pivot
sleeve onto the reel drive housing (22).
11. Use a press to install the 2 ball bearings (5) into housing (22) outer raceway.
Install the reel shaft-driven (1) to the reel drive housing (22).
12. Install the retaining ring (6) and spacer (7) o the reel drive housing (22).
13. Install the hipro key (20) onto the reel shaft-driven (1). Apply anti-seize
lubricant at the top of the key.
14. Install the reel pulley (8) onto the reel shaft-driven (1). Secure the reel pulley
with the lock nut (9).
15. Torque tighten the lock nut to 36.6 to 44.7 N∙m (27 to 33 ft-lb).
16. If removed, install the bushing (10) into the idler arm (26).
17. Use a press to install the 2 ball bearings (18) to the idler arm (26) outer
raceway and secure with a retaining ring (29).
18. Install and secure the idler arm into the reel driving housing with the socket
head screw (11) and nut (10).
Page 4–9 Traction and Reel Drive Systems: Service and Repairs