Making The Measurement - Agilent Technologies ESA-E Series Measurement Manual

Making Bluetooth™ Measurements
Making the Output Power Measurement
Figure 3-2 Time Domain Power and Timing Analysis

Making the Measurement

1. Press the
2. Press the
NOTE The factory default settings provide a Bluetooth™ compliant measurement. For
special requirements, you may need to change some of the settings. Any changes
from the default values may result in invalid measurement data.
Press
parameters for the current measurement to their default settings.
• Mode setup and frequency/channel parameters.
• Measurement setup parameters.
18
key.
Measure
Output Power
Meas Setup , More (1 of 2)
Use the Mode Setup and
parameters for all measurements made within the current mode. For further
information, refer to Chapter 1 of this document.
These are measurement specific parameters that are changed using the
measurement setup ( Meas Setup
settings at any time by pressing
Defaults . For further information on measurement setup parameters, refer to
the ESA-E Series Spectrum Analyzers Bluetooth™ Measurement Personality
User's Guide.
key.
, Restore Meas Defaults
Frequency Channel keys to change these
) menu. Parameters can be returned to default
,
Meas Setup More (1 of 2)
at any time to return all
and
Restore Meas
Chapter 3