Making a Wideband CDMA Measurement
Use the
NOTE
Personality key, as well as any equivalent SCPI command that
performs the function of that key.
1. Install the Modulation Analysis Measurements Personality as
2. Make sure that the base transceiver station is in service with only
3. Connect the device being measured and the spectrum analyzer input
Figure 4-1
Measurement Setup
Chapter 4
key to get a quick explanation of any Modulation Analysis
Help
described in the "Getting Started" chapter of this guide.
the pilot Walsh channel active.
as shown in
Figure 4-1
Making Modulation Analysis Measurements
Making a Wideband CDMA Measurement
or
Figure
4-2.
25