Results; Troubleshooting Hints - Agilent Technologies ESA-E Series Measurement Manual

Making Bluetooth™ Measurements
Making the Initial Carrier Frequency Tolerance Measurement

Results

This result is either a positive or negative number in Hz indicating the frequency
difference between the measured frequency and the specified nominal carrier
frequency.
Figure 3-7 Initial Carrier Frequency Tolerance Measurement Results
NOTE Results are shown in numeric format beneath the trace. To view this section of the
window in its entirety, press the
then press the
window.

Troubleshooting Hints

• If an external attenuator is used, be sure to include the attenuation value in the
• If an external preamplifier is used, be sure to include the gain value in the
26
menu key. This can also be used for zooming in on the trace
Zoom
measurement. This can be accessed by pressing
measurement. This can be accessed by pressing
Next Window menu key until it is highlighted,
Input
Input
, .
Ext Atten
, .
Ext Gain
Chapter 3