4.
To show the password as it is being typed, check the Show
Password check-box.
5.
Save the Viewmode Credentials settings by clicking the Change
button. Alternatively, clear the settings by clicking the Reset
button.
To change the View Mode settings, do the following steps:
1.
Log in to the unit's Configurator GUI with Administrator
credentials. See
device configuration" (page 38)
2.
Click the -view mode settings link under MANAGEMENT
SETTINGS in the left-hand settings menu
Figure 45. Configurator GUI (VIEW MODE SETTINGS dialog)
• The VIEW MODE SETTINGS dialog will be shown.
3.
To allow or prohibit access to any device-configuration settings,
click the relevant drop-down, and click the Disabled or Enabled
setting:
• If the Disabled option is selected for a device-configuration
setting, the setting for that category will be visible but not
accessible to ordinary users.
© 2021 Cisco and/or its affiliates. All rights reserved.
Device configuration using the configurator interface
"Accessing the Cisco FM1000 Gateway for
for more information.
(Figure 45 (page
93)).
Page 93 of 138