Table of Contents
Advertisement
obeying predefined rules for management of incoming and outgoing data
packets.
IMPORTANT
For detailed information on the predefined rules for smart
VLAN packet management, refer to the
management" (page 87)
To connect the unit to a VLAN that is part of the local wireless network, do
the following steps:
1.
Click the -vlan settings link under ADVANCED SETTINGS in the
left-hand settings menu.
• The VLAN SETTINGS dialog will be shown
(page
Figure 40. Configurator GUI (VLAN SETTINGS dialog)
2.
Connect the unit to a VLAN that is part of the local wireless
network by checking the Enable VLANs check-box.
3.
Check the Enable VLANs check-box.
4.
Enter the management identification number of the VLAN (used
to communicate with the device's operating system) in the
Management VLAN ID: field.
5.
Enter the native identification number (the VLAN ID implicitly
assigned to untagged packets received on trunk ports) in the
Native VLAN ID: field.
6.
Save the VLAN settings by clicking the Save button. Alternatively,
clear the settings by clicking the Reset button.
© 2021 Cisco and/or its affiliates. All rights reserved.
Device configuration using the configurator interface
table at the bottom of this section.
86)).
NOTE
The same Management VLAN ID must be used on all
Fluidmesh devices that are part of the same mesh
network.
"Rules for packet
(Figure 40
Page 86 of 138
Advertisement
Table of Contents
