Table of Contents
Advertisement
Figure 10. Cisco FM1000 Gateway (COM port)
2.
Connect the other end of the RS-232 serial cable to the computer
that you will use to configure the unit.
3.
Set the serial port speed of the computer to 115 200 baud. For
detailed instructions on how to do this, refer to the Help content
supplied by your computer's manufacturer.
4.
Log in to the Fluidmesh command line interface (CLI). For
detailed instructions on how to use the CLI, refer to the
Fluidmesh Networks CLI User Manual. The factory-set login
details are as follows:
• Username: admin
• Password: admin
5.
Enter the command factory, and press the Enter key.
6.
You will be asked if you want to reset the unit to factory defaults.
To proceed with the firmware reboot, type yes and press the
Enter key.
© 2021 Cisco and/or its affiliates. All rights reserved.
Hardware installation
Page 30 of 138
Advertisement
Table of Contents
