IMPORTANT
If an Ethernet-based system using multiple peripheral
components is connected to the wireless network, assign each
peripheral component a fixed IP address. If dynamic IP
addressing is used, the components may not be accessible to
third-party software that relies on the components for data
input.
A typical example is a video surveillance system equipped with
multiple CCTV cameras. Each camera must be assigned a
fixed IP address to be accessible to the video-recording
software.
Fluidmesh gateway devices
The Cisco FM1000 Gateway features two Ethernet ports, located on the
front panel and rear panel of the unit. Usually, one port is connected to the
local network switch. The second can be used for configuration and
maintenance purposes.
© 2021 Cisco and/or its affiliates. All rights reserved.
Getting Started
Page 22 of 138