Table of Contents
Advertisement
Figure 31. Sample Block list (Example 3)
6.
Save and close the *.CSV file.
To upload a Pass list or Block list using the Configurator interface, do the
following steps:
1.
Click the –pass list / Block list link under ADVANCED
SETTINGS in the left-hand settings menu.
Figure 32. Configurator (Pass list / Block list dialog)
• The Pass list / Block list dialog will be shown
(page
2.
Choose the type of list to be uploaded by clicking the correct List
Type: radio button.
3.
Click the Choose File button. Upload the saved *.CSV file using
the upload dialog.
• The contents of the uploaded *.CSV file will be shown in
the Pass list / Block list Status section.
To apply the list settings contained in the *.CSV file, click the Apply
Settings button.
To clear the Pass list or Block list settings without deleting the *.CSV file,
click the Clear Pass list or Block list button.
To delete the Pass list or Block list *.CSV file, click the Reset button.
© 2021 Cisco and/or its affiliates. All rights reserved.
Device configuration using the configurator interface
74)).
(Figure 32
Page 74 of 138
Advertisement
Table of Contents
