Table of Contents
Advertisement
Figure 19. RACER™ Cloud connection info status (Connected)
Configure the unit using either of the following methods:
• To do a centralized (online) configuration of the unit using the FM
Racer interface, refer to the Fluidmesh Networks FM Racer User
Manual.
• To do a local (offline) configuration using the Configurator interface,
refer to
"Device configuration using the configurator interface" (page
36).
If the unit is not able to connect to the internet:
• The unit will revert to a Fallback state.
• The unit's IP address will automatically be set to 192.168.0.10/24.
If the unit connects to the internet in Provisioning Mode, but cannot
connect to the Partners Portal, the unit's IP address will automatically be
set to 192.168.0.10/24. If the unit cannot connect to the Partners Portal,
verify that the Partners Portal can be reached by doing the following
steps:
1.
Check that the Ethernet cable leading to the unit is properly
connected.
2.
Check that the local DNS server can resolve
3.
Check that the local DNS server can resolve the IP address of
the FM Racer Cloud server, and that the address can be reached.
4.
Check the network firewall settings. Port 443 must be enabled.
5.
Click
this link.
• The Fluidmesh Partners Portal page should open in your
browser.
6.
If the Partners Portal cannot be accessed, contact the Fluidmesh
support desk by sending an E-mail to support@fluidmesh.com.
7.
If the Partners Portal does not come back online, do a local
(offline) configuration using the Configurator interface. For further
information, refer to
interface" (page
If the unit cannot connect to the internet in Provisioning Mode, try to
connect to the internet by doing the following steps:
© 2021 Cisco and/or its affiliates. All rights reserved.
Device configuration using the configurator interface
"Device configuration using the configurator
36).
this address.
Page 45 of 138
Advertisement
Table of Contents
