Table of Contents
Advertisement
8.7. How do I connect an existing pre-FM Racer device to
FM Racer?
IMPORTANT
Please note that Cisco FM Ponte kit and FM1300 Otto
transceivers are not compatible with FM Racer.
To configure and maintain these transceivers, refer to the
Fluidmesh Installation and Configuration manual for the
specific device.
To connect compatible Fluidmesh devices that were purchased before FM
Racer came online, do the following steps:
1.
Upgrade your device firmware to a version that supports FM
Racer.
2.
Connect a computer to the Fluidmesh device.
3.
Launch the offline Configurator interface.
4.
Switch to Online Cloud-Managed mode as shown in the
Switching between offline and online modes section of your
device's Installation and Configuration manual.
5.
Adjust the device configuration as needed using the Fluidmesh
Partners Portal.
© 2021 Cisco and/or its affiliates. All rights reserved.
NOTE
As of October 2018, the most current firmware
versions are as follows:
• 1.2.1 (FM1000 Gateway and FM10000
Gateway gateways)
• 7.5.1 (FM FM1200 Volo)
• 8.2.1 (All FM x200 variants)
• 9.0.1 (All FM x500 variants)
Troubleshooting
Page 121 of 138
Advertisement
Table of Contents
