Table of Contents
Advertisement
Authentication
Method
TTLS
PEAP
12. Save the RADIUS settings by clicking the Save button.
Alternatively, clear the settings by clicking the Reset button.
6.7.7. NTP Configuration
All Fluidmesh radio transceiver units have a built-in clock.
No manual time-setting controls are provided. Instead, the unit has
network time protocol (NTP) functionality that allows it to synchronize its
time settings with a chosen internet time server. If the unit cannot
synchronize with its primary time server, and the host name of a backup
time server is entered, the unit defaults to synchronizing with the backup
server.
CAUTION
The same NTP configuration must be set for all Fluidmesh
units in the wireless network.
If the same NTP settings are not applied to all units, the
network may encounter timestamp conflicts and/or equipment
malfunctions.
To change the NTP settings, do the following steps:
1.
Click the -ntp link under ADVANCED SETTINGS in the left-hand
settings menu.
• The NTP dialog will be shown
© 2021 Cisco and/or its affiliates. All rights reserved.
Device configuration using the configurator interface
Available Inner Authentication Methods
• PAP (Password Authentication Protocol)
• CHAP (Challenge-Handshake
Authentication Protocol)
• MSCHAP (Microsoft Challenge-Handshake
Authentication Protocol)
• MSCHAPV2
• MD5
• GTC
• MSCHAPV2
• MD5
• GTC
(Figure 38 (page
84)).
Page 83 of 138
Advertisement
Table of Contents
