Abs - KTM 1290 SUPER ADVENTURE S 2021 Owner's Manual

7.27.24 ABS

Info
Do not open the throttle when switching on or off.
Press the RIGHT or LEFT button briefly when activating
the motorcycle traction control and the motor slip regu-
lation.
Hold down the RIGHT or LEFT button when switching off
the motorcycle traction control and motor slip regula-
tion.
When ABS mode Offroad is active, the MSR is not
active.
After the ignition is switched on, the motorcycle
traction control and engine traction torque control are
enabled again.
–
Press the SET button or RIGHT button when the menu is closed.
–
Press the UP button or DOWN button until Motorcycle is
marked. Press the SET or the RIGHT button to open the menu.
Warning
Danger of accidents An incorrectly selected ABS mode
makes control of the vehicle considerably more diffi-
cult.
The ABS modes are each only suitable for certain
E02083-01
conditions.
–
Always select an ABS mode that is compatible with
the surface of the ground.
–
Press the UP button or DOWN button until ABS is marked.
–
Press the RIGHT or LEFT button to select between ABS modes.
Guideline
Only use Road ABS mode on asphalt.
Only use Offroad ABS mode on unpaved roads.
Info
The ABS mode can be switched during the journey.
Do not open the throttle during the selection.
If ABS mode Road is enabled, ABS controls both
wheels.
If the ABS mode Offroad is enabled, ABS controls later
and only on the front wheel. The rear wheel is not con-
trolled by ABS and may lock during braking maneuvers.
The curve dependent control and rollover protection are
only active in ABS mode Road.
DASH 7
55