Connecting The Relays - Enterasys I Series Hardware Installation Manual

This chapter describes power source and environmental requirements, and contains instructions
on setting up the I-Series switch.
Equipment needed:
• Phillips screwdriver
• Flat blade screwdriver
• Needle-nosed pliers
Electrical Hazard: Only qualified personnel should install or service this unit.
Riesgo Eléctrico: Nada mas personal capacitado debe de instalar o darle servicio a esta unida.
Elektrischer Gefahrenhinweis: Installationen oder Servicearbeiten sollten nur durch
ausgebildetes und qualifiziertes Personal vorgenommen werden.
Follow the order of the sections below for correct installation.
For information about...
Checking Environmental and Power Requirements
Special Considerations for Safe Use
Unpacking the I-Series Switch
Changing Alarm Relays from Normally Closed to Normally Open
Installing a Second IOM
Mounting the Switch
Connecting Power to the Switch

Connecting the Relays

Connecting to the Console Port
Connecting to the Network
Installing and Removing a Memory Card
Securing the IOM Cables
Completing the Installation
Installation
Refer to page...
Enterasys I-Series Hardware Installation Guide 2-1
2
2-2
2-4
2-5
2-6
2-7
2-11
2-19
2-22
2-23
2-24
2-31
2-34
2-35